Can I use a Flexite brand "Rapid Injection Systems" capsule injector for Valplast?

[nickate]

....or TCS materials????

If so what pressure should the Nitrogen regulator be set at?

Thanks for your responses!!!

 

[AJEL]

Tommy best to call Sol, I use 90psi on my Flexipress, Sol at Flexite 516-746-8147 USA Toll Free Telephone: 1-866-FLEXITE http://www.flexitecompany.com/Flexite Plus Brochure- New.pdf
plus is 245*c 475*f (I've used 249*c a few times) soak 14 min hold 5 min bench cool 15 min then quench if U must.
TCS is 288*c 550*f 11 min soak hold 5 min bench cool.
Either one is not as moisture sensitive as Valplast and easier to finish.

 

[nickate]

Thanks AJ!

 

[nickate]

AJ..... I went and bought the injection machine, Big daddy Nitrogen tank (good to 2015),regulator, and 2 flasks and a bunch of flexite lt. pink cartridges this evening .... Got quite the deal... but is the OLD injector--- no heater----.... I will fire it up and report back soon!

 

[jimi]

set nitrogen to 10 bar /145 psi