Armann Girrbach - milling angulated screw channel

[chr1978]

Can you mill angulated screw channels with motion 2 soon? I'm tired of sending designed crowns to a milling centre. It eats up a lot of profit. I know it requires a T bur but I hope it will be released soon.

Do you charge extra for angulated screw channels?

Just started using Dess Aurum tibases and they are amazing - and they cost 55% percent less in Denmark than Dynamic abutments tibases.

 

[Affinity]

Just add your own screw channel at the angle you want, add in CAM as abutment and manually mark screw channel.

 

[DESS-USA]

The AG folks should help you out since the ability to angulate the screw channel in exocad has been there for awhile and as Affinity stated it is in the CAM.
Unfortunately AG will not want to listen to one of their competitors tell them to fix their CAM to incorporate this solution...

 

[Affinity]

AG is a few years behind on many exocad features..

 

[A. M.]

I just milled a couple in my Mikro 5X and I use 3Shape.
No problem, and no special burr needed...
It's the way you nest it...

 

[Affinity]

Yeah you can setup multiple screw channel angles