JMN
Christian Member
Full Member
- Messages
- 12,205
- Reaction score
- 1,884
How do you get the surface texture that realistic?
How do you get the surface texture that realistic?
Thank you !tres jolie super!!!!
How do you get the surface texture that realistic?
Do You use diamond polishing compound and pamis if needed afterward. You mentioned rubber wheel, what brand?and what brand of diamond polishing compound do you like? I use Matrix it gives nice luster instead of glassy look, but the compound is pink in color, so if you have some pits in the surface, it's a problem. Thanks for inspiringI am using some fine diamond burs and try to mic nature. Also hand polishing is a must
hello drizzt
what is ' cubic zirconia' you are using as frame for your built up?
thanks i didn't know the word "cubic zirconia" for super trans zirconia in my range of super trans zirconia with around 600mpa its called "smile"Hello , cubic zirconia is a super translucent zirconia. Around 600 MPA instead of 1000-1200 of HT zirconia
Hopefully the tissue settles down interproximally, maybe after about 10-15 minutes?
thanks i didn't know the word "cubic zirconia" for super trans zirconia in my range of super trans zirconia with around 600mpa its called "smile"
you make great works and you are a great ceramist félicitation!!!!!
Incredible work.
What did you use, do, for the Inc 1/3rd, to get the low value without it being transparent? It's backed up with dentine, right, then what, TI5 + E60?
Now that you've done this case, everything else will seem easier..that is until you get your next hardest case...it's out there, just waiting for you, Drizzt
excuse me for my question i d'ont understand the expression backed with dentine and i added some g7 ?Thank you !!
I used a mix of TI3 and TI4 1:1 ,backed with dentine as you say, PS0 for the white area and HT 56 for the neck. Then on the second bake, I added some G7 on my mix, PS0 for the white area, and HT 54 for the neck. Covered everything with SI-06, no enamel used
Thank you !!
I used a mix of TI3 and TI4 1:1 ,backed with dentine as you say, PS0 for the white area and HT 56 for the neck. Then on the second bake, I added some G7 on my mix, PS0 for the white area, and HT 54 for the neck. Covered everything with SI-06, no enamel used