S
Slayfin
Member
Full Member
- Messages
- 55
- Reaction score
- 0
ok dear friends, I am trying to import scan data from sirona inlab 4.02 to my exocad in order to design my framework there...now we're is the problem: I managed to import the file to exocad by there the case goes wrong...I had problem defining the margin lines since it seems that the "preparation scans" was not made properly, in inlab I could design everything normally. but for my reasons I want to design in exocad...I can provide some photos tomorrow so you may see the problem..but so far has any of you tried to do this? any solutions on the matter? ?