Toto
Active Member
Full Member
- Messages
- 138
- Reaction score
- 10
Perhaps Patrick could answer this - I pressed 3 single crowns for a friend yesterday and they came up short of the margins . 3 single crowns in a 200g ring(thats how it was sent to me) but only one LT Ingot as the weight was just below .75 . I used the 200g cycle in my Ivoclar EP 3000 furnace.
Should I have used the 100 g setting? May be a sprueing technique failure?
Up until now I have had no mis presses -only one where I did not weigh and came up short of material.
Should I have used the 100 g setting? May be a sprueing technique failure?
Up until now I have had no mis presses -only one where I did not weigh and came up short of material.