McTeeth
Active Member
Full Member
- Messages
- 335
- Reaction score
- 37
Hi guys,
K, I'm trouble-shooted out on this one. I am doing a Maryland bridge via Trios scan. I don't want any dies. How do I accomplish this?
I copied the case and removed the bridge from order form. Imported raw scans from Trios...good so far. When I Model Buildered, I can proceed right till close and finished...good so far.
Now back on my Dental Manager, the preview box does not show what I created with Model Builder. Trim was not.
How do I create a basic model?
K, I'm trouble-shooted out on this one. I am doing a Maryland bridge via Trios scan. I don't want any dies. How do I accomplish this?
I copied the case and removed the bridge from order form. Imported raw scans from Trios...good so far. When I Model Buildered, I can proceed right till close and finished...good so far.
Now back on my Dental Manager, the preview box does not show what I created with Model Builder. Trim was not.
How do I create a basic model?