J
Joon Hong
Member
Full Member
- Messages
- 37
- Reaction score
- 7
i was nesting cases today with millbox for dwx52dc mill
everything was fine except one case containing 4unit anterior wax mill
number 7-10, 8 and 9 were veneer
i never had this type of problem with vhf mill
when i try to import stl, it says stl is either damaged or not supported
and the unit is in red
when i click ok on error pop up, it shuts millbox down
after few try, it didn't have error pop up, still in red, can't proceed to next step
it says something like it's in pr---- mode and only one object exist, can't add more item when i try to add milling disk
crown had some grey dots
my reseller tech support told me those grey dots are too thin
i tried adding like 5times
still doesn't work, and it is really not the thickness (at least by my guess)
like i said, never had this problem with vhf
anyone ran into this problem yet?
everything was fine except one case containing 4unit anterior wax mill
number 7-10, 8 and 9 were veneer
i never had this type of problem with vhf mill
when i try to import stl, it says stl is either damaged or not supported
and the unit is in red
when i click ok on error pop up, it shuts millbox down
after few try, it didn't have error pop up, still in red, can't proceed to next step
it says something like it's in pr---- mode and only one object exist, can't add more item when i try to add milling disk
crown had some grey dots
my reseller tech support told me those grey dots are too thin
i tried adding like 5times
still doesn't work, and it is really not the thickness (at least by my guess)
like i said, never had this problem with vhf
anyone ran into this problem yet?