Reply to thread

Message: <blockquote data-quote="Sevan P" data-source="post: 99905" data-attributes="member: 7766">I remember a month ago I was comparing a basic coping cut on both the DWX-50 and iMes 340i, I set the margin line offset in 3shape to .20mm and the 340I gave me a much thinner margin line compared to the DWX-50. Well no matter what I did I would always get a thinner margin line on the 340I not that it was chipping it was just thinner, well the 340I is about 3/4 if not more accurate over the DWX-50. I think the 50 Roland was around 20micron on accuracy and the 340i was like 3microns if I recall correctly, not 100% sure.So if your margin line is set to .10 then that too could be the issue, try cutting a .20mm on the margin line offset and see what happens, each mill will not cut the same.</blockquote>