A
anthonyy
New Member
- Messages
- 2
- Reaction score
- 0
I have an older MCXL and have noticed that water always pools in the chamber above the Sirona grate. No issues milling with emax and it drains shortly after the cycle is completed.
However, something is affecting my milling when attempting long span telio temp bridges. I get all sorts of error messages.
Any advice with this? I do see quite a bit of calcification buildup in the push up drain plug which attaches to the water tank. I’m thinking about using some vinegar to clean it or even unscrew the drain plug completely for a thorough clean.
Please advise. Thank you.
However, something is affecting my milling when attempting long span telio temp bridges. I get all sorts of error messages.
Any advice with this? I do see quite a bit of calcification buildup in the push up drain plug which attaches to the water tank. I’m thinking about using some vinegar to clean it or even unscrew the drain plug completely for a thorough clean.
Please advise. Thank you.