Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
VHF Burs
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Mike2" data-source="post: 249424" data-attributes="member: 943"><p>Call Jensen, if u use other tools u may get better or worse results. I use the vhf tools sold by Jensen and get 60-80 crown out of my #6 roughing tool and about 75-90 on the 1 mm and over 200 on the # 1 2 mm tool. I steam clean before every use and make sure to do collet maintenance weekly. I would suspect something going on besides the tools as they last longer than 35 units for me and I don't allow any chipped units out of the milling process. It does depend on materials, my number above r with Jensen XT it is less with the higher trans material as its harder. My 2 cents</p></blockquote><p></p>
[QUOTE="Mike2, post: 249424, member: 943"] Call Jensen, if u use other tools u may get better or worse results. I use the vhf tools sold by Jensen and get 60-80 crown out of my #6 roughing tool and about 75-90 on the 1 mm and over 200 on the # 1 2 mm tool. I steam clean before every use and make sure to do collet maintenance weekly. I would suspect something going on besides the tools as they last longer than 35 units for me and I don't allow any chipped units out of the milling process. It does depend on materials, my number above r with Jensen XT it is less with the higher trans material as its harder. My 2 cents [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
VHF Burs
Top
Bottom