Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Strange days indeed!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="JeffT" data-source="post: 359894" data-attributes="member: 1023"><p>Thanks for replies in previous post. Very helpful and much appreciated.</p><p></p><p>I had another funny one happen on Friday and would love to hear what you all think.</p><p></p><p>I milled a crown to fit a Straumann NC, 5.5 h, GH 1.0, and the crown milled much longer than the design (see pics)</p><p>DME's are latest from Strau and millbox is 22 vers. </p><p>I also milled the crown from a clean PC just to see if any change, but same results. </p><p>The crown is fully seated and contacts are loose. </p><p>I ended up designing crown as a prep and it was as designed, so honestly I am lost to what may be the cause. I did mill a Nobel implant also and it</p><p>was fine. </p><p>Could it be corrupted DME files? I haven't tried to mill another strau type yet but will try tomorrow. Files were from Strau website.</p><p>It's almost like the order is for 3mm GH height, but triple checked order and it is correct to the abutment.</p></blockquote><p></p>
[QUOTE="JeffT, post: 359894, member: 1023"] Thanks for replies in previous post. Very helpful and much appreciated. I had another funny one happen on Friday and would love to hear what you all think. I milled a crown to fit a Straumann NC, 5.5 h, GH 1.0, and the crown milled much longer than the design (see pics) DME's are latest from Strau and millbox is 22 vers. I also milled the crown from a clean PC just to see if any change, but same results. The crown is fully seated and contacts are loose. I ended up designing crown as a prep and it was as designed, so honestly I am lost to what may be the cause. I did mill a Nobel implant also and it was fine. Could it be corrupted DME files? I haven't tried to mill another strau type yet but will try tomorrow. Files were from Strau website. It's almost like the order is for 3mm GH height, but triple checked order and it is correct to the abutment. [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Strange days indeed!
Top
Bottom