JeffT
jeff
Full Member
- Messages
- 331
- Reaction score
- 13
Thanks for replies in previous post. Very helpful and much appreciated.
I had another funny one happen on Friday and would love to hear what you all think.
I milled a crown to fit a Straumann NC, 5.5 h, GH 1.0, and the crown milled much longer than the design (see pics)
DME's are latest from Strau and millbox is 22 vers.
I also milled the crown from a clean PC just to see if any change, but same results.
The crown is fully seated and contacts are loose.
I ended up designing crown as a prep and it was as designed, so honestly I am lost to what may be the cause. I did mill a Nobel implant also and it
was fine.
Could it be corrupted DME files? I haven't tried to mill another strau type yet but will try tomorrow. Files were from Strau website.
It's almost like the order is for 3mm GH height, but triple checked order and it is correct to the abutment.
I had another funny one happen on Friday and would love to hear what you all think.
I milled a crown to fit a Straumann NC, 5.5 h, GH 1.0, and the crown milled much longer than the design (see pics)
DME's are latest from Strau and millbox is 22 vers.
I also milled the crown from a clean PC just to see if any change, but same results.
The crown is fully seated and contacts are loose.
I ended up designing crown as a prep and it was as designed, so honestly I am lost to what may be the cause. I did mill a Nobel implant also and it
was fine.
Could it be corrupted DME files? I haven't tried to mill another strau type yet but will try tomorrow. Files were from Strau website.
It's almost like the order is for 3mm GH height, but triple checked order and it is correct to the abutment.