Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Community discussion
Implants
Pekkton/Anaxgum compared to Trilor/Crystal Ultra for Hyrid dentures.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="CoolHandLuke" data-source="post: 332688" data-attributes="member: 4850"><p>can speak only to Peek and the use of Trinia/Trilor </p><p></p><p>both are fairly straightforward to machine, very stable materials that don't heat up and wrap around your tools like hot plastics.</p><p></p><p>both only need good thin edge carbide tools, too high of a rake angle will cause tools to glance or not cut properly. trinia/trilor need to be routed, so each tool must pass with >24k rpm to get clean edges. wet or dry, finish is the same when routed.</p></blockquote><p></p>
[QUOTE="CoolHandLuke, post: 332688, member: 4850"] can speak only to Peek and the use of Trinia/Trilor both are fairly straightforward to machine, very stable materials that don't heat up and wrap around your tools like hot plastics. both only need good thin edge carbide tools, too high of a rake angle will cause tools to glance or not cut properly. trinia/trilor need to be routed, so each tool must pass with >24k rpm to get clean edges. wet or dry, finish is the same when routed. [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Community discussion
Implants
Pekkton/Anaxgum compared to Trilor/Crystal Ultra for Hyrid dentures.
Top
Bottom