Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Community discussion
Case Presentations
Peek
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="aqdental" data-source="post: 171974" data-attributes="member: 1450"><p>This is from C&M :</p><p>Bonding Ti bases and frameworks of Pekkton® ivory, in choosing cement, MultilinkHybrid® Abutment (Ivoclar Vivadent) is recommended.</p><p></p><p>1. The abutment is screwed onto the analog. Seal the screw channel of the titanium abutment and the Pekkton® ivory framwork with wax.</p><p></p><p>2. Carefully sandblast the surface of the titanium abutment with 110μm aluminum oxide and 3 bar pressure.</p><p></p><p>3. Also carefully sandblast the contact surface on the inside of the framework. 110μm aluminum oxide and 2 bar pressure.</p><p></p><p>4. Monobond plus is applied to the sandblasted surfaces to silanize them. Application time approx. 60 seconds.</p><p></p><p>5. Apply visio.link (Bredent) to the Pekktonivory surface with a single-use brush and light cure for 90 seconds (Dentacolor XS, Kulzer).</p><p></p><p>6. Apply the cement to the inner surface of the framework and place on the abutment.</p><p></p><p>7. Then follow the manufacturer›s instructions.</p></blockquote><p></p>
[QUOTE="aqdental, post: 171974, member: 1450"] This is from C&M : Bonding Ti bases and frameworks of Pekkton® ivory, in choosing cement, MultilinkHybrid® Abutment (Ivoclar Vivadent) is recommended. 1. The abutment is screwed onto the analog. Seal the screw channel of the titanium abutment and the Pekkton® ivory framwork with wax. 2. Carefully sandblast the surface of the titanium abutment with 110μm aluminum oxide and 3 bar pressure. 3. Also carefully sandblast the contact surface on the inside of the framework. 110μm aluminum oxide and 2 bar pressure. 4. Monobond plus is applied to the sandblasted surfaces to silanize them. Application time approx. 60 seconds. 5. Apply visio.link (Bredent) to the Pekktonivory surface with a single-use brush and light cure for 90 seconds (Dentacolor XS, Kulzer). 6. Apply the cement to the inner surface of the framework and place on the abutment. 7. Then follow the manufacturer›s instructions. [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Community discussion
Case Presentations
Peek
Top
Bottom