Need help with 3m1 emax

[rebel dental lab]

Really new to the system and need help getting 3m1 as the shade. I have a case with( 4 units) 2 veneers 1 crown and one crown over a post and core. I know I have to press a coping for the post and core and then build any advice helpful.

Thanks Ferris

 

[TheLabGuy]

I would let the post/core decide what type of material for me on this one........
-If less than 1.2mm buccal clearance on the post/core, I'd go with MO1 for all four units.
-If more than 1.2mm buccal clearance on the post/core, I'd go with LT C1 for all four units.
The LT will mask out the post/core, but you have to have enough room to do so, if you don't then go with MO/HO depending on how much room you really have. Just to keep everything in harmony, I would go ahead and press everything else the same.......saves some money on the ingots too. Hope that helps.......and as for C1 to 3m1......take a little violet/pink and mix with gray and stain your cervical with it.