Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Zirconium
KDF Zircom (or others) Sintering Times
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="FastShipper" data-source="post: 310942" data-attributes="member: 22030"><p>Hey all,</p><p> We recently purchased the KDF Zircom sintering furnace and I was wondering what peoples settings are for sintering zirconia; the last lab I worked at we used one setting for all zirconia, didn't matter brand or anything, and never had any issues, but I don't remember what the settings were.</p><p></p><p> I should throw in that I do have one sintering process put in there but haven't used it yet, I pulled it from the manual but it doesn't state that it's a good starting point or anything, hence why I'm asking. It's setup as follows:</p><p></p><p>Step 1: 1000 degrees C for 40min</p><p>Step 2: 1500 degrees C for 1hour</p><p>Step 3: 1500 degrees C for 2hours</p><p>Step 4: 400 degrees C for 1hour 30min</p><p>Step 5: 300 degrees C for 30min</p></blockquote><p></p>
[QUOTE="FastShipper, post: 310942, member: 22030"] Hey all, We recently purchased the KDF Zircom sintering furnace and I was wondering what peoples settings are for sintering zirconia; the last lab I worked at we used one setting for all zirconia, didn't matter brand or anything, and never had any issues, but I don't remember what the settings were. I should throw in that I do have one sintering process put in there but haven't used it yet, I pulled it from the manual but it doesn't state that it's a good starting point or anything, hence why I'm asking. It's setup as follows: Step 1: 1000 degrees C for 40min Step 2: 1500 degrees C for 1hour Step 3: 1500 degrees C for 2hours Step 4: 400 degrees C for 1hour 30min Step 5: 300 degrees C for 30min [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Zirconium
KDF Zircom (or others) Sintering Times
Top
Bottom