T
twaite
Member
Full Member
- Messages
- 82
- Reaction score
- 0
Hopefully someone can be of assistance to me
well we have a new problem something I have never seen until recently. When we go to break out the denture after processing and the last 10mm are not processed. They are soft as if the acrylic never cured.
The water is where is should be, the flask are all the way in the clamp, the sprewing is spot on. The temp is set to 100c, we boil them for 40 minutes. There was no back flow.
Today we processed two cases in the moring with no problems then this afternoon doing all the same procedures we had two cases not cure all way. in facted all 4 cases were flasked and boiled out at the same time, but the ones that failed were the ones that sat on the counter until that first two were processed. we use the rapidflask from whipmix on our second pour rather than stone. never had this issue till we cleaned out our processor a couple weeks ago,.
Is it possible for the white shields, the flask lids to stop radiating heat? That's the only thing I can think of.
Please, is there anything you can tell us.
well we have a new problem something I have never seen until recently. When we go to break out the denture after processing and the last 10mm are not processed. They are soft as if the acrylic never cured.
The water is where is should be, the flask are all the way in the clamp, the sprewing is spot on. The temp is set to 100c, we boil them for 40 minutes. There was no back flow.
Today we processed two cases in the moring with no problems then this afternoon doing all the same procedures we had two cases not cure all way. in facted all 4 cases were flasked and boiled out at the same time, but the ones that failed were the ones that sat on the counter until that first two were processed. we use the rapidflask from whipmix on our second pour rather than stone. never had this issue till we cleaned out our processor a couple weeks ago,.
Is it possible for the white shields, the flask lids to stop radiating heat? That's the only thing I can think of.
Please, is there anything you can tell us.