Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Community discussion
Fixed
Formlabs 2 models
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="LuthorCorp" data-source="post: 327908" data-attributes="member: 17611"><p>I can vouch depending on the size of the models and angulation a full tray can take around 6 hours if you are doing full arched models at around a 70 degree tilt from the tray. However doing a full tray at miniscule tilt will take anywhere from 3-4 hours or so at 100 microns. For less detail specific printing you can throw it at 140micron and that takes about 40% less time, but if you start going to 50 or 25 micron expect to be printing for 15-20+ hours.</p></blockquote><p></p>
[QUOTE="LuthorCorp, post: 327908, member: 17611"] I can vouch depending on the size of the models and angulation a full tray can take around 6 hours if you are doing full arched models at around a 70 degree tilt from the tray. However doing a full tray at miniscule tilt will take anywhere from 3-4 hours or so at 100 microns. For less detail specific printing you can throw it at 140micron and that takes about 40% less time, but if you start going to 50 or 25 micron expect to be printing for 15-20+ hours. [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Community discussion
Fixed
Formlabs 2 models
Top
Bottom