Al.
Well-Known Member
Full Member
- Messages
- 3,664
- Reaction score
- 904
A common question on this forum. What ingot to use to cover a metal post.
For me without a doubt in the anterior region H0.
I pressed #7 HO2 3/4 full contour lingual, #8,9 & 10 C2 LT.
Dusted with Neutral fired.
Stained the gin 1/2 C3 feathering it up higher on the HO2 crown.
Fired
Build C3 1/2 D2 1/2 fired.
Stained where I wanted for effects, set stain.
Layer incisal.
Glaze with glaze paste then rubber wheel lightly and lightly touch with diamond paste.
This is at insert just after cement clean up.
Tissue should drop down to cover the dark teeth below the margins.
For me without a doubt in the anterior region H0.
I pressed #7 HO2 3/4 full contour lingual, #8,9 & 10 C2 LT.
Dusted with Neutral fired.
Stained the gin 1/2 C3 feathering it up higher on the HO2 crown.
Fired
Build C3 1/2 D2 1/2 fired.
Stained where I wanted for effects, set stain.
Layer incisal.
Glaze with glaze paste then rubber wheel lightly and lightly touch with diamond paste.
This is at insert just after cement clean up.
Tissue should drop down to cover the dark teeth below the margins.