Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Zirconium
Dipping.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Bryce Hiller" data-source="post: 276565" data-attributes="member: 18969"><p>I've had breakage issues, particularly in connector areas. I've talked to other labs, and they've had this issue as well. I'm using Beyond Plus from Origin almost exclusively at this. Many advantages: 4-hour sinter cycle, MUCH stronger than STML (1,100 MPa vs 750ish),looks just as good (if not better),liquids are water-based (no furnace contaminants),list goes on. I'll never do another crown in STML, honestly. It's a good ZR, but we were just having too many crowns breaking. Haven't had a single issue with Origin.</p></blockquote><p></p>
[QUOTE="Bryce Hiller, post: 276565, member: 18969"] I've had breakage issues, particularly in connector areas. I've talked to other labs, and they've had this issue as well. I'm using Beyond Plus from Origin almost exclusively at this. Many advantages: 4-hour sinter cycle, MUCH stronger than STML (1,100 MPa vs 750ish),looks just as good (if not better),liquids are water-based (no furnace contaminants),list goes on. I'll never do another crown in STML, honestly. It's a good ZR, but we were just having too many crowns breaking. Haven't had a single issue with Origin. [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Zirconium
Dipping.
Top
Bottom