Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAD
Crown over Ti Base
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="sndmn2" data-source="post: 272837" data-attributes="member: 1639"><p>I designed a case with two separate crowns , not connected, on one case. I set it up on the order form as if it was through Argen . Designed the case and milled the zirconia in house and ordered the Ti bases from Argen. Both crowns fit nicely on the bases but did not index correctly on the model. . Not a full rotation about a half. Should I just scan the bases as a die? Any thoughts before I try again ? Thanks.</p></blockquote><p></p>
[QUOTE="sndmn2, post: 272837, member: 1639"] I designed a case with two separate crowns , not connected, on one case. I set it up on the order form as if it was through Argen . Designed the case and milled the zirconia in house and ordered the Ti bases from Argen. Both crowns fit nicely on the bases but did not index correctly on the model. . Not a full rotation about a half. Should I just scan the bases as a die? Any thoughts before I try again ? Thanks. [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAD
Crown over Ti Base
Top
Bottom