Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAD
Crown Bottoms over Ti Bases
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="tyjthomas" data-source="post: 343324" data-attributes="member: 15395"><p>I had that problem - was using Straumann to bases and rotational fit was always too loose. Similar setup with Exocad, millbox, and Roland mills. Exocad was fine (Straumann locks their library so fit couldn’t be adjusted…) but I found that in millbox, I had to shrink the fitting surfaces by about 0.020 mm or something like that to get the tighter fit. In my case I had to actually go into the settings of millbox and add a greater internal reduction value than what was standardly available. </p><p></p><p>I will say during the process I had blamed Exocad, the zirconia, and the sintering oven … finally was able to fix it with that one setting in millbox when nesting the file. Hope that helps!</p></blockquote><p></p>
[QUOTE="tyjthomas, post: 343324, member: 15395"] I had that problem - was using Straumann to bases and rotational fit was always too loose. Similar setup with Exocad, millbox, and Roland mills. Exocad was fine (Straumann locks their library so fit couldn’t be adjusted…) but I found that in millbox, I had to shrink the fitting surfaces by about 0.020 mm or something like that to get the tighter fit. In my case I had to actually go into the settings of millbox and add a greater internal reduction value than what was standardly available. I will say during the process I had blamed Exocad, the zirconia, and the sintering oven … finally was able to fix it with that one setting in millbox when nesting the file. Hope that helps! [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAD
Crown Bottoms over Ti Bases
Top
Bottom