NicelyMKV
Well-Known Member
Full Member
- Messages
- 3,557
- Reaction score
- 262
I have been using this system for a little over a year now and have had very good results. This system only mills Zirconia and some type of acrylic or plastic for casting. I do not mill in house but I do the scanning and design work and then send it to Compartis, which is their milling center. I usually get the substructures back in 2 or 3 days. Single units are very simple but bridgework is more difficult with this system than others. If you complete the scan and then have an imperfection anywhere on the 3D model you have to rescan the entire case. I was told today that they would be moving Compartis, which is in pennsylvania, to China. My lease on this system will be up in about 6 months and due to this fact will go swiftly out the door. Lets hope for more available systems soon.
Thanks,
Jason
Thanks,
Jason