ceramill motion 2 zirconia conversion f-code?

[feowey91]

hi there. I have searched far and wide but haven't found any reliable info on the conversion factors for my ceramill motion 2. I currently run cares visual and the ceramill nesting software with AG or Straumann ziconia which use the f code shrinkage factor. I've been experimenting with other zirconia but unfortunately the shrinkage code is different. i was given the conversion formula from AG which is 1-(1/shrinkagecode) and have tried all katana varieties (UTML/HTML/YML),beyond plus, 3m, etc. but the crowns are a bit too small which do not fit on the preps and have open contacts. I have obtained a VITA Syntering oven and am running the specified the temperature ranges and program for the corresponding zirconia which i am working with and they have gotten a bit better but are still a bit too small.
I also ran into another conversion formula here on the forum F= (1.28477- code) x200 but the crowns are just way too large. Any help would be much appreciated.
Thanks!