Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Ceramill Motion 2 Tool usage
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="BobCDT" data-source="post: 189108" data-attributes="member: 3119"><p>The 2MM tool does most of the cutting and is good for 20ish units. The 1MM tool is good for 40-50 Titanium abutments. The mill mills the abutments like a lathe so the accuracy and finish is awesome. There is very little post processing needed. In addition, the blank is not held in the mill from the interface so there is no load on the interface during milling. Most mills today are holding blanks from the interface end.</p></blockquote><p></p>
[QUOTE="BobCDT, post: 189108, member: 3119"] The 2MM tool does most of the cutting and is good for 20ish units. The 1MM tool is good for 40-50 Titanium abutments. The mill mills the abutments like a lathe so the accuracy and finish is awesome. There is very little post processing needed. In addition, the blank is not held in the mill from the interface so there is no load on the interface during milling. Most mills today are holding blanks from the interface end. [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Ceramill Motion 2 Tool usage
Top
Bottom