Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Community discussion
Fixed
Casting component Guru assistance needed
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Brendon P Johnson" data-source="post: 284409" data-attributes="member: 20593"><p>I'm a general dentist in NZ and need to have a 5 unit non precious implant supported bridge </p><p>(three implants 16 15 and 12 sites and none are parallel ) on paralleled custom abutments , the bridge is to be temp cemented onto the abutments and cross pin (screwed) from the palatal aspect . My technician is a brilliant master tech and has advised that the non precious is too hard to tap with his tap set - used conventionally on precious castings . My question is ; are there any pre manufactured non precious screw thread housings for cross pinning which can be cast onto , or burn out thread housings that could be cast ? Or are there other non precious components - screw and housing ( non precious cast on to ability ) that could be re purposed . The bridge is a very large framework and precious content cost has been rejected by the patient at this stage . Your thoughts would be appreciated .</p></blockquote><p></p>
[QUOTE="Brendon P Johnson, post: 284409, member: 20593"] I'm a general dentist in NZ and need to have a 5 unit non precious implant supported bridge (three implants 16 15 and 12 sites and none are parallel ) on paralleled custom abutments , the bridge is to be temp cemented onto the abutments and cross pin (screwed) from the palatal aspect . My technician is a brilliant master tech and has advised that the non precious is too hard to tap with his tap set - used conventionally on precious castings . My question is ; are there any pre manufactured non precious screw thread housings for cross pinning which can be cast onto , or burn out thread housings that could be cast ? Or are there other non precious components - screw and housing ( non precious cast on to ability ) that could be re purposed . The bridge is a very large framework and precious content cost has been rejected by the patient at this stage . Your thoughts would be appreciated . [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Community discussion
Fixed
Casting component Guru assistance needed
Top
Bottom