DMC
Banned
- Messages
- 6,378
- Reaction score
- 260
I am looking for something....
Can someone (everyone) please walk over to a running mill,
look on screen at bottom left side....
You will see either G54, or G55, or G?? right next to the tool being used...T6 or whatever.
I suspect everyone is running in a G55 work-offset? Right? I need to be sure of this for something.
Also, if possible, can you post the first Tens lines of a program? The actual G-code.
Thanks in advance.
Scotty
Can someone (everyone) please walk over to a running mill,
look on screen at bottom left side....
You will see either G54, or G55, or G?? right next to the tool being used...T6 or whatever.
I suspect everyone is running in a G55 work-offset? Right? I need to be sure of this for something.
Also, if possible, can you post the first Tens lines of a program? The actual G-code.
Thanks in advance.
Scotty