Forums
New posts
Search forums
What's new
Featured content
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Community discussion
Implants
Anodizing TiBars without Metal Show through
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="TheLabGuy" data-source="post: 379032" data-attributes="member: 126"><p>PMMA is fine for show through because it's a temp...allows the Doc to try everything in before the zirc is made. Once PMMA is good to go, then you make the zirc, use blockout like you would on a normal implant case is what we do. No way to anonidize the bar white, thin zirconia will always bleed through...especially nowadays, with the addition of translucency into the zirconia.</p></blockquote><p></p>
[QUOTE="TheLabGuy, post: 379032, member: 126"] PMMA is fine for show through because it's a temp...allows the Doc to try everything in before the zirc is made. Once PMMA is good to go, then you make the zirc, use blockout like you would on a normal implant case is what we do. No way to anonidize the bar white, thin zirconia will always bleed through...especially nowadays, with the addition of translucency into the zirconia. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Community discussion
Implants
Anodizing TiBars without Metal Show through
Top
Bottom
