Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
AG Ceramill users unite!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Chalky" data-source="post: 276203" data-attributes="member: 13047"><p>contact the help desk and get them to look at the software... this is what I did. they assessed that there was an error with the tool sensor ( both of my mills had the same issue a few days apart) I had great experience in the service and help I received from the service technician who help me out. They essentially flew out and coordinated for the parts to arrive at my lab and did the change over at no cost to me. I predominantly wet mill and the issue turned out to be moisture in the sensor. all has been fine since. contact support!</p></blockquote><p></p>
[QUOTE="Chalky, post: 276203, member: 13047"] contact the help desk and get them to look at the software... this is what I did. they assessed that there was an error with the tool sensor ( both of my mills had the same issue a few days apart) I had great experience in the service and help I received from the service technician who help me out. They essentially flew out and coordinated for the parts to arrive at my lab and did the change over at no cost to me. I predominantly wet mill and the issue turned out to be moisture in the sensor. all has been fine since. contact support! [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
AG Ceramill users unite!
Top
Bottom