mdawda
Member
Full Member
- Messages
- 8
- Reaction score
- 2
Hi guys ,
I have a strange problem with the output i get after milling custom abutment.
1. the screw access channel is not milled fully
2. the screw channel diameter is narrow
3. the hex of the abutment milled is slightly bigger then required, so need to do all kind of alterations to make it seat even after milling
the CAM used is Picasoft and Machine is Yenadent D15 .
Kindly help me solve this issue, as company support is not good.
Thanks in advance ...
I have a strange problem with the output i get after milling custom abutment.
1. the screw access channel is not milled fully
2. the screw channel diameter is narrow
3. the hex of the abutment milled is slightly bigger then required, so need to do all kind of alterations to make it seat even after milling
the CAM used is Picasoft and Machine is Yenadent D15 .
Kindly help me solve this issue, as company support is not good.
Thanks in advance ...