Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Community discussion
Removable
4C Partial Dentures
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Jerry Hadley" data-source="post: 287392" data-attributes="member: 20739"><p>i have approximately ten in the mouth at this time. no problems yet. yes it may be c4 instead of 4c and blow up in may face but so far so good. i do not dehydrate or use their acrylic. i use regular self cure acrylic and it works fine. I use clear disk only so i have clear clasp on everyone i make. I see no need for using pink disk. i keep my scrap pieces of the clear disk and make clasp for other partials, i use hot air plastic welder i got at harbor freight and silicone glove. cut strip, heat it adapt to model leaving plenty for retention in acrylic. works great.</p><p>most negative part is when you vacuum the disk you have to watch carefully to make sure it doesnt bubble. if it starts to smoke turn heat off for 30-45 seconds then back on, repeat if necessary. if it gets too hot it WILL bubble. CONTROL YOUR TEMP!</p><p>Keep in mind it is semiflexible. if your are expecting flexibility of a valplast type partial you will be dissipointed.. not for every case.</p></blockquote><p></p>
[QUOTE="Jerry Hadley, post: 287392, member: 20739"] i have approximately ten in the mouth at this time. no problems yet. yes it may be c4 instead of 4c and blow up in may face but so far so good. i do not dehydrate or use their acrylic. i use regular self cure acrylic and it works fine. I use clear disk only so i have clear clasp on everyone i make. I see no need for using pink disk. i keep my scrap pieces of the clear disk and make clasp for other partials, i use hot air plastic welder i got at harbor freight and silicone glove. cut strip, heat it adapt to model leaving plenty for retention in acrylic. works great. most negative part is when you vacuum the disk you have to watch carefully to make sure it doesnt bubble. if it starts to smoke turn heat off for 30-45 seconds then back on, repeat if necessary. if it gets too hot it WILL bubble. CONTROL YOUR TEMP! Keep in mind it is semiflexible. if your are expecting flexibility of a valplast type partial you will be dissipointed.. not for every case. [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Community discussion
Removable
4C Partial Dentures
Top
Bottom