3Shape Scanner from diadem?

[Mark Jackson]

When are you buying a massive Roeders Mark to mill eMax, if you say it makes money.

I think it is a flop. Actually, I know it doesn't make money.

Go ahead and stroke that check.

No thank you. I'm just sharing what i know about some new products, and other ways that equipment might be put to use. If Dentsply an Glidewell make a gigantic splash with their new materials, it will just drive more volume to that kind of mill.

 

[DMC]

I doubt it. Pressing is the only profitable way to make it.

That's my point Mark. OK, the materials will still be used, but not milled.

Too expensive with the diamond tooling and overhead of the BIG mills.

The Math just does not add up.

 

[Mark Jackson]

I doubt it. Pressing is the only profitable way to make it.

That's my point Mark. OK, the materials will still be used, but not milled.

Too expensive with the diamond tooling and overhead of the BIG mills.

The Math just does not add up.

Unless you are the manufacturer and getting the blocks at intrinsic cost. Competitive products will cause prices to go down. I'm not disagreeing with you Scott. I don't do it, and there is a reason for that.