millennium
Active Member
Donator
Full Member
- Messages
- 898
- Reaction score
- 78
Good morning all,
Is there a significant difference between 0.3mm and 0.5mm finish as far as fit and occlusal anatomy, and overall look of a crown?
Intaglio surface(that ti base fits into) of a zr abutment or screw retained crown?
Some mills have an 0.5mm as the smallest bur.
Is there a significant difference between 0.3mm and 0.5mm finish as far as fit and occlusal anatomy, and overall look of a crown?
Intaglio surface(that ti base fits into) of a zr abutment or screw retained crown?
Some mills have an 0.5mm as the smallest bur.