The reality is,,,there will be more opportunity for Digital techs moving forward,,,,I hope that those techs who see that take advantage of the opportunity, I agree with you there will be some not motivated or reluctant to change or accept change.
Very Broad question, yet an important one.
We are in the process of converting some of our "traditional" labs to "Digital" besides the hurdles and complications of doing this, I wanted to pose the question (if your comfortable sharing) how your labs are coping with the transition.
The most...
I would almost bet any zirconia (any brand, 600-1500mpa) thick or not,,,would have a similar result when dropped.
Its Zirconia!
Sorry this happened, but it will happen.
Sounds silly, but make sure you are using correct tool....if it requires "taper" and your tool in straight, this could cause it!
Just thought I would mention it....(also double check tool paths)
Adam
Streamline Dental
What high temp are you guys firing the HT + ?
We are seeing a good result around 1525
We also "soak" a little longer by about 20-30 mins (due to number of units)
Generater would need to be "seamless" switch,,,,may be more costly......
then again,,,I am the one looking for help,,,,so may look into it!! lol
thanks
Anybody using a Battery Back-up on their furnaces 110v (Sintras)
When we have thunderstorms I get anxiety about loosing 100s of units each night to Power outage!
We often will get a small surge in power and only need a few minutes of battery assistance.,,,,
Anybody in a similar spot
Thanks...
We can not seem to make this material look good.
We have tried numerous Crowns of both materials.
We purchased the complete stains kits for each specific material (coloring liquids, Enhancers, Inhibitors)
Followed stain dipping techniques, adjusted after feedback from Amman.
Sintering at...
We run Sum3d/Millbox, its easy and good.
For larger machines, we just Switched to Hyperdent!
Still new to the software, nothing but good things to say about support from Jordan and his team!!
Adam
Streamline Dental
Panthera produces some of the best bars and implant solutions I have seen.
Easy to work with, but I think the quality sells itself.
Adam
Streamline Dental
Anybody know of Roland Repair company/person in Florida? (Avon Park)
Having a "Y" axis error and in need of support
Originally bought through a re seller in Canada, who does not sell equipment in the U.S (I am sure most people know which company)
If anybody has constructive ideas/advice...