Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
All Porcelain-Press
Zubler Vario Press 300 problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="SiKBOY" data-source="post: 151792" data-attributes="member: 1362"><p>I'm using 3mm sprue and it is quite short already . I'll get some 5mm sprue for my next press. Very minimal reaction layer and orange peel. It's a massive difference compared to before so I'm happy about that. </p><p></p><p>I'm shooting alox at 2 bar to divest as my glass bead air hose is broken. The margin is a little short on the sprue side only but no where near as much as before. Margin is fine everywhere else</p></blockquote><p></p>
[QUOTE="SiKBOY, post: 151792, member: 1362"] I'm using 3mm sprue and it is quite short already . I'll get some 5mm sprue for my next press. Very minimal reaction layer and orange peel. It's a massive difference compared to before so I'm happy about that. I'm shooting alox at 2 bar to divest as my glass bead air hose is broken. The margin is a little short on the sprue side only but no where near as much as before. Margin is fine everywhere else [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
All Porcelain-Press
Zubler Vario Press 300 problem
Top
Bottom