Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAD
Zirconia to Titanium interface table top mill
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="JohnWilson" data-source="post: 96553" data-attributes="member: 213"><p>Yes, because you will be unable to get the insertion direction for each access hole the same. I have not found a way to do it unless the fixtures are extremely parallel to one another which is rarely the case.</p><p></p><p>What I would like to be able to do is have the ability to do a dual mill where the tilt angle could be adjusted after the initial mill by marking the disk and then rotating the puck in the fixture and adjusting the tilt angle to fit the requirements. This would allow almost anything to be milled in a 4x if I am thinking clearly. </p><p></p><p>Truth is, my plans are another new mill this next quarter, I am shopping now.</p></blockquote><p></p>
[QUOTE="JohnWilson, post: 96553, member: 213"] Yes, because you will be unable to get the insertion direction for each access hole the same. I have not found a way to do it unless the fixtures are extremely parallel to one another which is rarely the case. What I would like to be able to do is have the ability to do a dual mill where the tilt angle could be adjusted after the initial mill by marking the disk and then rotating the puck in the fixture and adjusting the tilt angle to fit the requirements. This would allow almost anything to be milled in a 4x if I am thinking clearly. Truth is, my plans are another new mill this next quarter, I am shopping now. [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAD
Zirconia to Titanium interface table top mill
Top
Bottom