Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
P.O.S. VHF Mill and CADBLU SUCKS!!! I know more technical stuff then they do.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="andydentec" data-source="post: 234234" data-attributes="member: 1588"><p>I was having the same problem. I was going through touch off plates when the bur would Bury in halfway down the plate. After trial and error I put some dielectric grease on the underside of the touch plate with out using the lock washer. It has made a big difference so far. It just allows it to have that electric contact between the plate and the holder. I also added another ground contact from inside the shroud(my mill has two ground clips on the inside.)to metal conduit on the electrical box. So far I barely have a scratch on the touch off plate. Don't put too much Dielectric grease because everything will stick to it in areas that it squirts out of.</p></blockquote><p></p>
[QUOTE="andydentec, post: 234234, member: 1588"] I was having the same problem. I was going through touch off plates when the bur would Bury in halfway down the plate. After trial and error I put some dielectric grease on the underside of the touch plate with out using the lock washer. It has made a big difference so far. It just allows it to have that electric contact between the plate and the holder. I also added another ground contact from inside the shroud(my mill has two ground clips on the inside.)to metal conduit on the electrical box. So far I barely have a scratch on the touch off plate. Don't put too much Dielectric grease because everything will stick to it in areas that it squirts out of. [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
P.O.S. VHF Mill and CADBLU SUCKS!!! I know more technical stuff then they do.
Top
Bottom