E
erinspeed
Member
Full Member
- Messages
- 8
- Reaction score
- 0
When I was casting this wknd, one of the rings blew out and sent metal out into the casting well. I just figured that it was junk, so I dropped it in a sink of cold water so I could find out which refractory to start duping ASAP. When I was done casting everything else, I broke the now cold frame out. IT CAST!! Complete in every way, except where the sprue stopped where it blew out because it was too close to the ring.
Question is, Do I scrap this because I metallurgically (sp?) ruined it? Do I finish and polish and move on? This might seem like a stupid question to you vetrans, but I am self taught and learn more from my mistakes than than I do from my successes.
Oh, yeah: Bego Wironit cast in induction machine.
Question is, Do I scrap this because I metallurgically (sp?) ruined it? Do I finish and polish and move on? This might seem like a stupid question to you vetrans, but I am self taught and learn more from my mistakes than than I do from my successes.
Oh, yeah: Bego Wironit cast in induction machine.