npdynamite
Active Member
Full Member
- Messages
- 342
- Reaction score
- 0
Im working on a case in exocad that had been previously designed and I am removing an implant site and also need to modify the previously designed emergence profile. The problem is after making the modifications and re-merging I can not sculpt to smooth the lines between abutment base and crowns and on the former implant site that I had to close a hole on, I can't smooth the connection between the where exocad filled the hole and the rest of the design.
Also where there was a gap between the design and the new emergence profile from the implant. The "filled area" of this gap will not let me sculpt on it at all.
Any advice?
Also where there was a gap between the design and the new emergence profile from the implant. The "filled area" of this gap will not let me sculpt on it at all.
Any advice?