biodentg
Active Member
Full Member
- Messages
- 405
- Reaction score
- 33
Hello everyone, here is a BUG for EXOCAD that I was not able to fix after 2 hours I end up re-scanning this case again.
This happens often and people @ B&D couldn't help, so any ideas are welcome.
The path of insertion seems to be below the other arrows. And the scan orientation was set correctly in advance before I started designing this case.
Thanks for your help.
bio.
This happens often and people @ B&D couldn't help, so any ideas are welcome.
The path of insertion seems to be below the other arrows. And the scan orientation was set correctly in advance before I started designing this case.
Thanks for your help.
bio.