EXO..Scan fix?

[ps2thtec]

is there a fix for this? Yes it’s from an iterror scan and the bulge was not on the die ,just appears after tooth form drops.

 

[LarryRDC]

Appears there's some error where HD added scan part was aligned. Either free-form or edit the mesh in that area, then re-mark the margin.
I se that a lot in Itero scans. Firt thing I do is check for it before marking the margin

 

[Dentalmike]

? In bottoms menu choose do not block out undercuts

 

[RileyS]

This has only happened when there is a tiny hole in the mesh I couldn't see until I zoomed in a ton. Once I found it I open the edit mesh, circle the hole and cut it out then use the close holes option. Then go back to crown bottoms to redo that step.
?

 

[ps2thtec]

So I zoom in on the scan and found this inside prep? Wasn’t visible in my other pics.
Looks like a millipede.

 

[RileyS]

So I zoom in on the scan and found this inside prep? Wasn’t visible in my other pics.
Looks like a millipede.

View attachment 42685

I'd clean all that out. May have to use both the edit function and the form scan data function

 

[ps2thtec]

Thanks everyone for your feedback! Larry baled this tech idiot out.
Appreciate all !