ts4341
Well-Known Member
Full Member
- Messages
- 741
- Reaction score
- 102
DLN,
Its been awhile since i've just cutback & layered the incisal 1/3 area on a Emax press.
Case; 6 - 11, Female 28, Overall Shade A3.5 cervical,A3 body, youthful incisal, stumpf ND2..
My request was to use LTA3 or LTA2 with full facial cutcack and layer...
Problem, Doc wants HTA3 ingots used with incisal 1/3 cutback only..
If I stain mamelon & cervical with essence for 1st wash at 770c,
then use fluo glaze over the entire restoration for 2nd wash at 770c.
?? After layering Ceram over incisal 1/3, during contouring/finishing if you
hit ingot and remove some glazed area,
will this leave a mark or line between ceram material
and lithium disilicate after final glaze? Sorry I just can't remember,
I don't want a line going across that area.
Thanks T
Its been awhile since i've just cutback & layered the incisal 1/3 area on a Emax press.
Case; 6 - 11, Female 28, Overall Shade A3.5 cervical,A3 body, youthful incisal, stumpf ND2..
My request was to use LTA3 or LTA2 with full facial cutcack and layer...
Problem, Doc wants HTA3 ingots used with incisal 1/3 cutback only..
If I stain mamelon & cervical with essence for 1st wash at 770c,
then use fluo glaze over the entire restoration for 2nd wash at 770c.
?? After layering Ceram over incisal 1/3, during contouring/finishing if you
hit ingot and remove some glazed area,
will this leave a mark or line between ceram material
and lithium disilicate after final glaze? Sorry I just can't remember,
I don't want a line going across that area.
Thanks T