R
Ryan Gottlieb
Active Member
Full Member
- Messages
- 287
- Reaction score
- 62
i need a little help on this one.
this was milled with Cap FZ
colored with ZirckonZahn water based liquids
dried under heat lamp for about 1 hour
sintered in sintra plus (parameters pictured below)
i inspected the green state under microscope and didn't see any cracks prior to sintering.
i inspected the bridge after sintering and it looked and fit fine.
came in this morning (48hrs later) and was shocked to find this crack.
ideas?
this was milled with Cap FZ
colored with ZirckonZahn water based liquids
dried under heat lamp for about 1 hour
sintered in sintra plus (parameters pictured below)
i inspected the green state under microscope and didn't see any cracks prior to sintering.
i inspected the bridge after sintering and it looked and fit fine.
came in this morning (48hrs later) and was shocked to find this crack.
ideas?