Bonjour Frenchcadman,
Ca y est, îmes icore nous a contacté et le problème est résolu...
Oui manuellement ça marchait, mais comme on avait un usinage de bar en cours, je ne pouvais pas effectuer d'autres opérations pour vérifier si ce problème n'était lie qu'à la position #1...
À priori, cela...
Thanks to all of you for your help!!
I have talked to Imes Icore this morning and they find the solution!!
They told me that because the milling cutter at the position #1 was more solicitated than the others, there is like a very very small play and when the collet release the milling cutter...
Thanks for your help ;-)
"if the problem persists after doing maintenance, check that the air valves to open and close the collet are functioning properly."
That's what I'd like to do today, but I really don't know which ones are the air valve!! Do you Know?
"if your air compressor does not...
Thanks for your reply.
I've already done it manually and everything is ok, no problem like that!
I have change the tools too, and clean everything..
The air pressure is the same as usually (around 0.8) that's why I really don't understand...
Of course, like everybody, the first thing I thought...
thanks for your reply, I will do it again.
Our resealer told me to change the spindle. He told me that if the spindle took a knock, it's possible that the spring inside doesn't work well anymore...
I really don't think that's the problem...
Thank you for your reply :-)
I've already try, I remove everything, then clean, then retry...
I was doing a zirconium when it happen the 1st time.
I've clean everything, then start again and the job has been done.
But today, when I was doing a titanium bar, it happens again...
Hi everybody,
I will try to explain my problem in english (I am french) I hope that everyone is going to understand it...
So, I have an Imes Icore 450i, I use to work pmma, zirconium and metal.
Since yesterday I have a big problem with my machine. When the program start, everything is normal...