Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
VHF Touch Point Troubles
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="user name" data-source="post: 279487" data-attributes="member: 1719"><p>Replacement may or may not be needed...I would certainly remove the machines cover and give a little push to the green connectors at the top of the panel. Your problem is continuity. Id also check the wire harness and how its zip tied on the lower right side. Mine was snugged down too securely, and when the mill was moving, a wire had too sharp a flex point and broke.</p><p> I hope Eliseo is helping you. Hes 'da man.</p></blockquote><p></p>
[QUOTE="user name, post: 279487, member: 1719"] Replacement may or may not be needed...I would certainly remove the machines cover and give a little push to the green connectors at the top of the panel. Your problem is continuity. Id also check the wire harness and how its zip tied on the lower right side. Mine was snugged down too securely, and when the mill was moving, a wire had too sharp a flex point and broke. I hope Eliseo is helping you. Hes 'da man. [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
VHF Touch Point Troubles
Top
Bottom