Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Equipment
Tool Problem help on wet mill...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="RCKSTR" data-source="post: 267839" data-attributes="member: 11020"><p>Had the same issue with IMES. The machine starts and stops the flow of fluid above the tool storage area. The lubricant in the cooling fluid turns into a sticky gummy film after about a week causing a small build up on the shaft of the tools. Tool gets stuck in the collet. We cleaned the shanks of all the burs with a wire brush weekly.</p></blockquote><p></p>
[QUOTE="RCKSTR, post: 267839, member: 11020"] Had the same issue with IMES. The machine starts and stops the flow of fluid above the tool storage area. The lubricant in the cooling fluid turns into a sticky gummy film after about a week causing a small build up on the shaft of the tools. Tool gets stuck in the collet. We cleaned the shanks of all the burs with a wire brush weekly. [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Equipment
Tool Problem help on wet mill...
Top
Bottom