Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Equipment
Tool Problem help on wet mill...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="cadfan" data-source="post: 265896" data-attributes="member: 10618"><p>I am no Versamiller looks like theirs a small plastic ring in the tool changer to hold the tools and give them friction while the collet opens to hold the tool at his place. If there is not enough friction either or the collet opens not well ( dirty , air pressure near minimum) the tool is still in the collet than the mill makes a length control but expected only the collet without burr ( less Z) than you get an error</p><p>does this happen only with the same burr versus tool position the problems is maybe the ring or each tool position it looks like a collet problem</p></blockquote><p></p>
[QUOTE="cadfan, post: 265896, member: 10618"] I am no Versamiller looks like theirs a small plastic ring in the tool changer to hold the tools and give them friction while the collet opens to hold the tool at his place. If there is not enough friction either or the collet opens not well ( dirty , air pressure near minimum) the tool is still in the collet than the mill makes a length control but expected only the collet without burr ( less Z) than you get an error does this happen only with the same burr versus tool position the problems is maybe the ring or each tool position it looks like a collet problem [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Equipment
Tool Problem help on wet mill...
Top
Bottom