Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Community discussion
Removable
Thermoplastic Acrylics
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="AJEL" data-source="post: 91004" data-attributes="member: 1480"><p><strong></strong></p><p><strong>David </strong></p><p><strong>TCS good equipment but I would keep a laser thermo meter on hand and use it regularly, I will check with TCS I have no experience with their denture material, sounds interesting. Diamond D was not developed for a preheat system such as a nylon furnace system. Without the heat (or low heat) you could load in the aluminium cartridge & inject the Astron1180 (remember to add the stabilizer to your type III stone) then process in your M9 if it works same as astron processor again I have no experience with the M9, although I know the Astron process and the Nevin quite well, although they have different guts I have both in my little lab. </strong></p><p><strong><em>This sounds just so awkward of a way to process a denture. You loose the advantage of injection when you remove the flask from the machine and place it in the processor. I suppose you would have a pre closed flask and make double use of a nylon (valplast style) flask.</em></strong></p></blockquote><p></p>
[QUOTE="AJEL, post: 91004, member: 1480"] [B] David TCS good equipment but I would keep a laser thermo meter on hand and use it regularly, I will check with TCS I have no experience with their denture material, sounds interesting. Diamond D was not developed for a preheat system such as a nylon furnace system. Without the heat (or low heat) you could load in the aluminium cartridge & inject the Astron1180 (remember to add the stabilizer to your type III stone) then process in your M9 if it works same as astron processor again I have no experience with the M9, although I know the Astron process and the Nevin quite well, although they have different guts I have both in my little lab. [I]This sounds just so awkward of a way to process a denture. You loose the advantage of injection when you remove the flask from the machine and place it in the processor. I suppose you would have a pre closed flask and make double use of a nylon (valplast style) flask.[/I][/B] [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Community discussion
Removable
Thermoplastic Acrylics
Top
Bottom