Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Roland MDX-50
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="cosmetic1" data-source="post: 347340" data-attributes="member: 24098"><p>I've been using it for over a year now and the machine is working every day cutting ZR without any problems. The advantage of using MDX-50 is that it is cheap, strong and accurate. Half price of DWX50 However, there is a lot of knowledge that must be learned to use it for dental purposes. Especially CAM setup is difficult, at first I managed to do it with the deskproto recommended here, I tried fusion360, but it was too difficult so I went back to deskproto again. PMMA will be cut, but I think it will take a considerable amount of time to get it right. If you want to make a digital denture, I think you will use a 3D printer. Also, the round material holder from the PDI is not suitable for hard materials, the vibration will loosen the screws and the disc will come off. I sell this triple disc holder on EBay for the time being. Please take a look if you are interested.</p></blockquote><p></p>
[QUOTE="cosmetic1, post: 347340, member: 24098"] I've been using it for over a year now and the machine is working every day cutting ZR without any problems. The advantage of using MDX-50 is that it is cheap, strong and accurate. Half price of DWX50 However, there is a lot of knowledge that must be learned to use it for dental purposes. Especially CAM setup is difficult, at first I managed to do it with the deskproto recommended here, I tried fusion360, but it was too difficult so I went back to deskproto again. PMMA will be cut, but I think it will take a considerable amount of time to get it right. If you want to make a digital denture, I think you will use a 3D printer. Also, the round material holder from the PDI is not suitable for hard materials, the vibration will loosen the screws and the disc will come off. I sell this triple disc holder on EBay for the time being. Please take a look if you are interested. [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Dental-CAM
Roland MDX-50
Top
Bottom