Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Equipment
Roland DWX 52DCi vs 52D
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Darren S" data-source="post: 335520" data-attributes="member: 3089"><p>We have both of these machines. The 52D is slightly faster as it does not have to change pucks. The DCi takes a couple minutes to grab the puck and load it for milling. Both machines are good work horse machines. We like the DCi since we can load it in the afternoon and mill over night. Depends on how you will set up your workflow. Single molars take 20-30 minutes to mill. Three unit bridges take about an hour or so. Hope that helps.</p></blockquote><p></p>
[QUOTE="Darren S, post: 335520, member: 3089"] We have both of these machines. The 52D is slightly faster as it does not have to change pucks. The DCi takes a couple minutes to grab the puck and load it for milling. Both machines are good work horse machines. We like the DCi since we can load it in the afternoon and mill over night. Depends on how you will set up your workflow. Single molars take 20-30 minutes to mill. Three unit bridges take about an hour or so. Hope that helps. [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Equipment
Roland DWX 52DCi vs 52D
Top
Bottom